Utica PEG-C Bedienungsanleitung

INSTALLATION MANUAL AND OPERATING INSTRUCTIONSPEG-CGAS FIRED BOILERSFOR STEAM HEATINGUtica Boilers  P.O. Box 4729  Utica, NY 13504

VENT SYSTEM MODIFICATIONWhen an existing boiler is removed from a common venting system, the common ventingsystem is likely to be too large for the pr

PAGE 9VENT DAMPER INSTALLATIONAND INSTRUCTIONSINSTALLATIONNOTE: REFER TO FIGURE 8 BELOW FOR STEPS 1-71. Place Vent Damper on or as close to vent ou

PAGE 10CONNECTING GAS SERVICEConnect gas service meter to control assembly in accordance with the latest revision ofANSI Z223.1 and local codes or uti

LIGHTING PROCEDURE FOR BOILER WITHINTERMITTENT PILOT SYSTEM.FOR YOUR SAFETY READ BEFORE OPERATING.A. This appliance is equipped with an ignition syst

C. Use only your hand to push in or turn gas control knob. NEVER USE TOOLS. If theknob will not push in or turn by hand, dont try to repair it, ca

PAGE 13E. Do not use this appliance if any part hasbeen under water. Immediately call a qualifiedservice technician to inspect the applianceand to rep

PAGE 14NORMAL SEQUENCE OF OPERATIONOn a call for heat:1.) The thermostat will actuate completing the circuit between T and T.2.) The damper will then

PAGE 15CONNECTING SUPPLY ANDRETURN PIPING, WATER CHILLED MEDIUM1. When the boiler is used in connection with refrigerated system, connect supply andr

PAGE 16GENERAL INSTRUCTIONSBefore seasonal start up it is advisable to have a competent service agency check theboiler for soot and scale in the flue

TO CLEAN THE BOILER FLUEWAYS:1. Remove the burners from the combustion chamber by raising the burners upwardfrom the manifold orifices and pulling tow

TABLE OF CONTENTSSafety Symbols & Warnings ... Page 1Installation

4. Electronic Low Water Cut-off: Operation may be checked by opening the drain valvein the back side of the boiler. This will drain the water from the

PAGE 19CHECKING AND ADJUSTING THE GAS IGNITION COMPONENTSThe gas input to the boiler can be adjusted by removing the protective cap on thepre

PAGE 20FIGURE 19PEG-C REPLACEMENT PARTS - PILOTITEM # PART # DESCRIPTION OTY.1 PB01301 PILOT-Q350A 24 VOLT 12 HW-024.01 SCREW #10-32X3/16 23 MS-00

PEG-C REPLACEMENT PARTS - BASEPAGE 21FIGURE 211 3542202 MANIFOLD PEG112C 13542203 MANIFOLD PEG150C3542204 MANIFOLD PEG187C3542205 MANIFOLD PEG225C

PEG-C REPLACEMENT PARTS - JACKETSFIGURE 22PAGE 221 31423001 SIDE PANEL LEFT (ALL) 12 31422802 FRONT PANEL PEG112C 131422803 FRONT PANEL PEG150C314

PEG-C REPLACEMENT PARTS - HEAT EXCHANGERFIGURE 23PAGE 23ITEM PART# NUMBER DESCRIPTION OTY.1 100-2-15.01 E-Left Hand Section 12 100-2-14.01 E-Cent

PEG-C REPLACEMENT PARTSFRONT PANEL CONTROLSPAGE 24FIGURE 241 GA-004.00 GAUGE WTR LEVEL 12 PF-033.02 PIPE FIT NPL 1/2"X4" 13 WCO1901 ELWC

PAGE 25FIGURE 25PEG-C REPLACEMENT PARTS - ELECTRICALITEM PARTNUMBER NUMBER DESCRIPTION OTY.1 EF-013.01 ELEC. J-BOX 4X4X1/2 22 37414401 WIRE PRES.

FRONT VIEWLEFT SIDE VIEW RIGHT SIDE VIEW3741801 PAGE 26 REV: 15, July 2003RATINGS, DATA, AND DIMENSIONSNATURAL GAS STEAM BOILERS*A.G.A Heating

PAGE 1IMPORTANT! READ ALL INSTRUCTIONS BEFORE INSTALLING.WARNING:1. Keep boiler area clear and free from combustible materials, gasoline a

INSTALLATION PROCEDUREWARNING:Improper installation, adjustment, alteration, service ormaintenance can cause injury or property damage.1. The in

PAGE 3FIGURE 1VENTILATION & COMBUSTION AIRWARNING:AIR OPENINGS TO COMBUSTION AREA MUST NOT BEOBSTRUCTED. BY FOLLOWING THE INSTRUCTIONS BELOW,

FIGURE 4PAGE 4FIGURE 3FIGURE 25. When the boiler is installed in a confined space and all air is provided from the outdoorsthe confined space shall be

CONNECTING SUPPLY AND RETURN PIPING1. Suggested piping for steam heating system can be seen in figure 5 below. Actualpiping may vary based on sys

PAGE 6FIGURE 6bSUGGESTED PIPING FOR A MODULAR STEAM BOILERSPUMPED RETURNSGRAVITY RETURNSFIGURE 6a

VENT INSTALLATIONWARNING:This boiler shall not be connected to any portion of a mechanicaldraft system operating under positive pressure.1. The vent p